Replacing Motorcycle Kill Switch, Starter Button, and right control group. 2013 Kawasaki Ninja
The start button was busted on my Ninja. This is how I swapped it out. Unhook the connection to the engine harness. Unhook the two leads to the front brake. Take out the two screws on the back of the switch pod. Separate the two halves. Replace with the new two halves. Hook up the brake switch leads. connect back to the wire harness. Tighten the everything up. Make sure you have enough slack to turn. Done.
8 thoughts on “Replacing Motorcycle Kill Switch, Starter Button, and right control group. 2013 Kawasaki Ninja”
Comments are closed.
I was wanting to replace my engine kill switch with a light up switch , but mine seem s to also turn on my fuel pumps? Does yours?
How did u jump it across the terminals
good job!
Awesome job!
You failed to show the 2 cable connections under the gas tank.
how did you look that whole part up on ebay,,, i need one too
ok thanks
Where buy give link